Lancer L4-2.4L SOHC (2005)
(If more than one row is displayed in the table, select the appropriate ECU part number.)
Click on the check mark to begin reprogramming.
NOTE:
It will take up to 10 minutes to complete the reprogramming.
h.
This message will display when the reprogramming is successfully completed.
Go to Step 9 to complete this bulletin procedure.
8.
K-LINE FLASH VEHICLES ONLY Reflash the PCM as follows:
a.
STV ONLY. If you just transferred the new reprogramming data from the Reflash Update CD 8/06 to the MUT-III hard drive, now transfer the
reprogramming data from the MUT-III laptop to the memory card. (Use the port on the left side of the MUT-III laptop.) Select ECU
Reprogramming, then Memory Card Transfer. A status bar will display while the data is loading into the memory card.
When the memory card data transfer is complete, remove the memory card from the laptop and install it in the VCI.
b.
MEDIC-II and STV. Connect the following equipment:
^
VCI (Vehicle Communication Interface) - MB991824
^
MUT-III main harness B (red) - MB991911
^
12-13 pin adapter (Outlander only) - MB991855
c.
Connect the VCI to the vehicle.
