Lancer L4-2.4L SOHC (2005)
d.
Select "Memory Card Transfer".
When the memory card data transfer is complete, remove the memory card from the laptop and install it in the VCI. Then go to Step 7 for CAN-FLASH
VEHICLES ONLY or Step 8 FOR K-LINE FLASH VEHICLES.
7.
CAN-FLASH VEHICLES ONLY:
IMPORTANT:
DO NOT DISCONNECT THE MEDIC-II LAPTOP. DO NOT USE VCI STANDALONE REPROGRAMMING.
The following equipment is required for PCM reprogramming on CAN-Flash vehicles:
^
MEDIC-II PC
^
Reprogramming Database on DVD-ROM (Reflash Update CD 8106 or later for this concern)
^
VCI (Vehicle Communication Interface) - MB991824
^
MUT-III main harness A (blue) - MB991910
^
USB 2.0 cable - MB991827
^
"Engine Compartment/Control Module" labels - p/n MSSF-024G-00
Connect this equipment in the same manner as for normal vehicle diagnosis. When reprogramming a CAN-Flash vehicle, the VCI and MEDIC-II laptop
must be connected. DO NOT use VCI Standalone on CAN-Flash vehicles.
a.
In the MUT-III System Select menu, click on the car symbol at the bottom of the screen.
b.
Connect the VCI to the vehicle. DO NOT DISCONNECT THE LAPTOP.
