Lancer L4-2.4L SOHC (2005)
2. Insert the hexagonal bit socket into the arrow section in the figure. Completely loosen the bolt, and then remove the steering wheel air bag module
assembly.
NOTE: Use a hexagonal bit socket or a hexagonal wrench having an effective length of 75 mm (0.2 inches) or more in the hexagonal section and
the diameter of 8 mm or more.
[[D]] DRIVER'S AIR BAG MODULE REMOVAL
WARNING
-
The air bag module must not be measured with such equipment as an ohmmeter, nor disassembled.
-
The removed air bag module should be stored in a clean, dry place with the deployment surface facing up.
[[E]] C"LOCK" SPRING REMOVAL
WARNING: The removed clock spring should be stored in a clean, dry place.
[[F]] AIR BAG MODULE REMOVAL (FRONT PASSENGER'S SIDE)
WARNING:
-
When the passenger's air bag module is removed, do not damage the engagement of the pawls.
-
The removed passenger's air bag module should be stored in a clean, dry place with facing the deployment surface facing up.
Insert the screwdriver (-) into the position specified in the figure and lift the screwdriver upward to release the pawls engaged, and then remove the
passenger's air bag module.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of air bag modules only according to the specified procedure.