Lancer L4-2.4L SOHC (2005)
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and seat belt pre-tensioner operation.
[[B]]PRE-TENSIONER CONNECTOR DISCONNECTION
Pre-tensioner
1. Use a flat-tipped screwdriver to pull out forward and unlock the locking button of the harness-side connector.
2. Disconnect the pretensioner connector.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of seat belt pre-tensioner only according to the specified procedure.
Scan Tool
1. When installing the new seat belt pre-tensioner, refer to "INSPECTION".
2. Connect the negative (-) battery cable.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition, switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
3. Connect scan tool MB991958 to the data link connector.
4. Turn the ignition switch to the ON position.
5. Check DTCs using scan tool MB991958 to ensure entire SRS operates properly. Confirm that the DTCs other than 26 and 28 are not set.
