mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Seat Belt Reminder Lamp > < Diagram Information and Instructions|Page 4737
Page 3
background image

(timer operation).

-

Sounds the tone alarm 12 cycles (after 0.5 seconds) if any of the following conditions is met when sixty seconds or more have elapsed since the
ignition switch is turned "ON". One cycle consists of five-second "on" and then three-second "off".

NOTE:  Once the tone alarm has sounded 12 cycles, it does not sound again until the vehicle speed reduces to 3 km/h (2 mph) or less even if any
of the following conditions is met.

a. The vehicle speed has reached 8 km/h (5 mph) while the seat belt switch is turned on (driver's seat belt is not fastened) with the ignition switch

"ON.

b. The seat belt switch has been turned on (driver's seat belt has not been fastened) for at least ten seconds while the ignition switch has been

turned "ON" and the vehicle speed has been 8 km/h (5 mph) or more.

The tone alarm stops sounding if the ignition switch or the seat belt switch is turned off (the driver's seat belt is fastened) while the timer operation is
active.

Seat Belt Reminder Lamp > < Diagram Information and Instructions|Page 4737