Lancer L4-2.4L SOHC (2005)
Stabilizer Link: Testing and Inspection
Stabilizer Link Ball Joint Breakaway Torque Check
STABILIZER LINK BALL JOINT BREAKAWAY TORQUE CHECK
Required Special Tool:
^
MB990326: Preload Socket
1. After shaking the ball joint stud several times, install the nut to the stud and use special tool MB990326 to measure the breakaway torque of the
ball joint.
Standard value: 0.5 - 1.5 Nm (4.4 - 13.3 inch lbs.)
2. If the measured value exceeds the standard value, replace the stabilizer link.
3. If the measured value is lower than the standard value, check that the ball joint turns smoothly without excessive play. If so, it is possible to re-use
that ball joint.