Lancer L4-2.4L SOHC (2005)
REMOVAL AND INSTALLATION
Required Special Tool:
-
MB990480: Glass Holder
REMOVAL SERVICE POINT
<<A>> WINDSHIELD REMOVAL
1. To protect the body (paint surface), apply cloth tape to all body areas around the installed
2. Make mating marks on the windshield and body.
3. Using piano wire.
1. Using a sharp-point drill, make a hole in the windshield adhesive.
2. Pass the piano wire from the inside of the vehicle through the hole.
3. Using a sharp-point drill, make a hole in the windshield adhesive.
4. Pass the piano wire from the inside of the vehicle through the hole.
CAUTION: Do not let the piano wire touch the edge of the windshield.
5. Pull the piano wire alternately from the inside and outside along the windshield to cut the adhesive.
CAUTION: Putting glass adhesive knife too deeply into windshield adhesive may damage windshield.