Lancer Evolution L4-2.0L DOHC Turbo (2003)
still parallel.
NOTE: When adjusting the jaws in parallel, make sure the knob is in the position shown in the figure.
3. Tighten the bolt with a wrench to disconnect the tie rod end.
<<C>> FRONT AXLE NO.1 CROSSMEMBER ASSEMBLY REMOVAL
Retain the crossmember with a transmission jack, and then remove the crossmember mounting bolt
INSTALLATION SERVICE POINT
>>A<< STABILIZER BAR INSTALLATION
Align the identification color on the left side of the stabilizer bar with the right end of the bushing.
INSPECTION
^
Check the front axle No. 1 crossmember for cracks or damage.