Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
1. Prize the clip of the door beltline molding using a flat-tipped screwdriver in the order of the numbers (from 1 to 4) shown in the figure. Lift the
vehicle front side of the door beltline molding.
NOTE: The flat-tipped screwdriver cannot be used at clips 5 and 6 of the door beltline molding shown in the figure.
2. Lift the door beltline molding in the direction of the arrow in the figure, then remove the door beltline molding.
[[C]] DOOR OPENING WEATHERSTRIP OUTER REMOVAL
Make the tool as shown in the figure, and remove the weatherstrip from the door panel.
INSTALLATION SERVICE POINTS
]]A[[ DOOR OPENING WEATHERSTRIP OUTER INSTALLATION
The clip color identifies the left and right weatherstrips so be sure to see the colors so as to install correctly.