Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
1. Jack up and support the font axle crossmember, remove the front axle crossmember mounting bolt.
2. Check the hoses and harnesses for roughness, and then remove the front axle crossmember assembly with the rear roll stopper and the steering gear
and linkage installed.
INSTALLATION SERVICE POINTS
[A] JOINT COVER GROMMET INSTALLATION
Install the joint cover grommet by aligning the projection of the steering gear and linkage assembly with the mating mark of the joint cover grommet
as shown in the figure.
[B] STABILIZER BAR/STABILIZER BUSHING/STABILIZER BAR BRACKET INSTALLATION
Install the stabilizer bar, the stabilizer bushing and the stabilizer bar bracket as shown in the figure.
[C] STEERING COLUMN SHAFT ASSEMBLY AND STEERING GEAR AND LINKAGE ASSEMBLY CONNECTION/STEERING
COLUMN BOLT INSTALLATION