Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Brake Pad: Service and Repair
BRAKE PAD CHECK
CAUTION:
If there is a significant difference in the thicknesses of the pads on the left and right sides, check moving parts (Refer to See: Brake
Rotor/Disc/Testing and Inspection/Brake Disk Thickness Check).
1. Visually check the thickness of brake pad from the inspection hole of the caliper body.
Standard value:
9.85 mm (0.39 inch) [Front]
9.0 mm (0.35 inch) [Rear]
Limit: 2.0 mm (0.08 inch)
2. When the thickness is lower than the limit value, replace both brake pads (right and left) as a set.
BRAKE PAD REPLACEMENT
CAUTION:
^
Take care not to contact the parts or tools to the caliper because the paint of caliper will be scratched. And if there is brake fluid on the
caliper, wipe it off quickly.
^
Whenever a pad must be replaced, replace both LH and RH wheel pads as a set to prevent the vehicle from pulling to one side when
braking.
1. While pressing the cross spring by hand, remove the pin from the brake caliper assembly.
2. Remove the cross spring from the brake caliper assembly.