Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Brake Rotor/Disc: Testing and Inspection
Brake Disk Thickness Check
BRAKE DISK THICKNESS CHECK
1. Using a micrometer, measure disk thickness at eight positions, approximately 45 degrees apart and 10 mm (0-4 inch) in from the outer edge of the
disk.
Standard value:
32.0 mm (1.26 inch) [Front]
22.0 mm (0.87 inch) [Rear]
Limit:
30.0 mm (1.18 inch) [Front]
20.0 mm (0.79 inch) [Rear]
NOTE: Thickness variation (at least 8 positions) should not be more than 0.015 mm (0.0006 inch).
CAUTION:
^
After a new brake disk is installed, always grind the brake disk with on-the-car type brake lathe. If this step is not carried out, the brake
disk run-out exceeds the specified value, resulting in judder.
^
When the on-the-car type lathe is used, first install M12 flat washer on the stud bolt in the brake disk side according to the figure, and
then install the adapter. If the adapter is installed with M12 flat washer not seated, the brake disk rotor may be deformed, resulting in
inaccurate grinding.
^
Grind the brake disk with all wheel nuts diagonally and equally tightened to the specified torque 100 Nm (74 ft-lb). When all numbers of
wheel nuts are not used, or the tightening torque is excessive or not equal, the brake disk rotor or drum may be deformed, resulting in
judder.