Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
[F] FRONT CAMSHAFT BEARING CAP ASSEMBLY INSTALLATION
CAUTION:
When the mounting bolts are tightened with the front camshaft bearing cap tilted, the front camshaft bearing cap is damaged. Install the
front camshaft bearing cap properly to the cylinder head and camshaft.
1. Install the front camshaft bearing cap to the cylinder head, and temporarily tighten the camshaft bearing front cap to the specified torque in the
order of the figure (1).
Tightening torque: 17 ± 3 Nm (13 ± 2 ft-lb)
2. Tighten the front camshaft bearing cap again to the specified torque in the order of the figure (2).
Tightening torque: 30 ± 2 Nm (23 ± 1 ft-lb)
3. After installing the front camshaft bearing cap, check that the paint marks of camshaft sprocket and of timing chain, the timing mark of crankshaft
pulley, and the T-mark position of ignition timing indicator are aligned correctly.
[G] ROCKER COVER ASSEMBLY INSTALLATION
1. Wipe off the sealant on the mating surface of the rocker cover assembly and the cylinder head and timing chain case assembly, and degrease the
surface where the sealant is applied.
CAUTION:
After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the oil or water to the sealant application area
or start the engine.
2. Apply sealant to the joint between the cylinder head and timing chain case assembly as shown in the figure and install the rocker cover assembly to
the cylinder head.
Specified sealant: Three bond 1217G or equivalent
NOTE: Install the rocker cover assembly immediately after the application of sealant.