Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
CAUTION:
^
When the tightening angle is smaller than the specified tightening angle, the appropriate tightening capacity cannot be secured.
^
When the tightening angle is larger than the specified tightening angle, remove the bolt to start from the beginning again according to the
procedure.
5) Tighten the crankshaft pulley center bolt by 60 degrees angle once more. Make sure the paint mark of crankshaft pulley center bolt is aligned
with the paint mark of crankshaft pulley as shown in the illustration "B."
[B] DRIVE BELT INSTALLATION
CAUTION:
^
To reuse the drive belt, install it by aligning the arrow mark on the backside of belt marked at the removal with the rotating direction.
^
Check that the notches of the notched pulley and the notches of the drive belt are fit correctly.
^
Check that the drive belt is installed in the center of the flat surface of the flat pulley.
1. Install the drive belt to each pulley as shown in the figure.
2. Set an special tool MB992278 to the pulley bolt of the auto-tensioner. Then, rotate the auto-tensioner counterclockwise and remove the L-shaped
hexagon wrench fixing the auto-tensioner.
3. Apply tension to the drive belt while slowly turning the auto-tensioner clockwise.