Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
1. Remove the sealant and grease on the top surface of cylinder block and on the bottom surface of the cylinder head. Then, degrease the sealant
application surface.
2. Apply the sealant to the top surface of cylinder block as shown in the figure.
Specified sealant: Three bond 1217G or equivalent
3. Install the cylinder head gasket to the cylinder block.
NOTE:
^
Install the cylinder head gasket immediately after applying sealant.
^
When the cylinder gasket is installed to the cylinder block, check that the sealant is securely applied to the bead line of the cylinder head
gasket.
4. Apply the sealant to the top surface of cylinder head gasket as shown in the figure.
Specified sealant: Three bond 1217G or equivalent
CAUTION:
After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the oil or water to the sealant application area