Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
]]A[[ RIVET/FRONT FLOOR FRONT PANEL HEAT PROTECTOR/FRONT FLOOR REAR PANEL HEAT PROTECTOR/RIVET
INSTALLATION
Use a riveter to tighten the rivet by the following procedure.
1. Insert part A of rivet into the riveter, and insert the rivet into the assembling area.
2. Operate the tool's handle while pushing the flange surface of rivet by riveter. Part A of rivet is cut and the rivet is tightened.
]]B[[ HEATED OXYGEN SENSOR INSTALLATION
Tighten the heated oxygen sensor to the specified torque by using special tool MB991953.
Tightening torque: 44 ± 5 N.m (33 ± 3 ft-lb)