Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
/Page-603034.png)
Q: Do all the resistances measure 1 kohms or more?
YES [M/T] : Go to Step 5.
YES [TC-SST] : Go to Step 6.
NO : Go to Step 13.
STEP 5. Check the wiring harness between joint connector (CAN3) C-127 and ECM connector B-10 [M/T] for a short to ground. Measure the
resistance at joint connector (CAN3) C-127.
CAUTION:
-
Disconnect the negative battery terminal.
-
A digital multimeter should be used.
-
The test wiring harness should be used.
1. Disconnect joint connector (CAN3), and measure the resistance at the wiring harness side of joint connector (CAN3).
2. Measure the resistance between joint connector (CAN3) terminal 4 and body ground.
OK: 1 kohms or more
3. Measure the resistance between joint connector (CAN3) terminal 15 and body ground.
OK: 1 kohms or more
Q: Do all the resistances measure 1 kohms or more?
YES : Check intermediate connector C-131, and repair if necessary. If the intermediate connector is in good condition, repair the wiring harness
between joint connector (CAN2) C-104 and joint connector (CAN3) C-127.
NO : Go to Step 14.
STEP 6. Check the wiring harness between joint connector (CAN3) C-127 and shift lever connector C-27 [TC-SST] for a short to ground.
Measure the resistance at joint connector (CAN3) C-127.
CAUTION:
-
Disconnect the negative battery terminal.
-
A digital multimeter should be used.
-
The test wiring harness should be used.