Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
/Page-603056.png)
NO : Go to Step 13.
STEP 5. Check the wiring harness between joint connector (CAN3) C-127 and ECM connector B-10 [M/T] for a short to power supply.
Measure the voltage at joint connector (CAN3) C-127.
1. Disconnect joint connector (CAN3), and measure the voltage at the wiring harness side of joint connector (CAN3).
2. Turn the ignition switch to the ON position.
3. Measure the voltage between joint connector (CAN3) terminal 4 and body ground.
OK: 4.7 V or less
4. Measure the voltage between joint connector (CAN3) terminal 15 and body ground.
OK: 4.7 V or less
Q: Do all the voltages measure 4.7 V or less?
YES : Check intermediate connector C-131, and repair if necessary. If the intermediate connector is in good condition, repair the wiring harness
between joint connector (CAN2) C-104 and joint connector (CAN3) C-127.
NO : Go to Step 14.
STEP 6. Check the wiring harness between joint connector (CAN3) C-127 and shift lever connector C-27 for a short to power supply. Measure
the voltage at joint connector (CAN3) C-127.
1. Disconnect joint connector (CAN3), and measure the voltage at the wiring harness side of joint connector (CAN3).
