Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
/Page-603200.png)
4. Measure the voltage between joint connector (CAN1) terminal 19 and body ground.
OK: 1 V or less
Q: Do all the voltages measure 1 V or less?
YES : Go to Step 58.
NO : Repair the wiring harness between joint connector (CAN1) C-105 and ETACS-ECU connector C-301.
STEP 25. Check the wiring harness for line-to-line short. Measure the resistance at ETACS-ECU connector C-301
CAUTION: Disconnect the negative battery terminal.
1. Disconnect ETACS-ECU connector C-301, and check that there is continuity at the harness side of ETACS-ECU
2. Check that there is continuity between ETACS-ECU connector terminals 6 and 7.
OK: No continuity
Q: Is the check result normal?
YES : Go to Step 37.
NO : Go to Step 26.
STEP 26. Check the wiring harness between joint connector (CAN1) C-105 and combination meter connector C-04 for line-to-line short.
Measure the resistance at joint connector (CAN1) C-105.
1. Disconnect joint connector (CAN1), and check that there is continuity at the harness side of joint connector (CAN1)
