Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Knock Sensor: Removal and Replacement
KNOCK SENSOR
REMOVAL AND INSTALLATION
CAUTION:
-
When the knock sensor replacement is performed, use scan tool MB991958 to initialize the learning value (Refer to Precautions Before
Service - Initialization Procedure for Learning Value in MFI Engine.)
-
Do not drop or hit the knock sensor against other components. Internal damage may result, and the knock sensor will need to be
replaced.
Pre-Removal And Post-Installation Operation
Removal Steps 1-2
INSTALLATION SERVICE POINT
]]A[[ KNOCK SENSOR INSTALLATION
Set the connector of the knock sensor to the position shown in the figure, and tighten it to the specified torque.