Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
/Page-1282001.png)
Air Bag: Service and Repair
Knee Air Bag Module
KNEE AIR BAG MODULE
REMOVAL AND INSTALLATION
WARNING:
-
Never attempt to disassemble or repair the knee air bag modules. If faulty, replace it.
-
Do not drop the knee air bag modules or allow contact with water, grease or oil. Replace it if a dent, crack, deformation or rust is
detected.
-
Do not expose the knee air bag modules to temperatures over 93—C (200—F).
-
After deployment of the air bag, replace the air bag module with a new one.
-
Wear gloves and safety glasses when handling air bags that have already deployed.
-
An undeployed knee air bag module should only be disposed of in accordance with the procedures.
-
When removing and installing the front passenger seat, be sure to carry out accuracy check occupant classification sensor after the seat
has been installed in the vehicle.
Pre-removal Operation
Removal Steps 1-4
REMOVAL SERVICE POINTS
[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION
