Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Slide the outer housing of the driver's air bag module connector in the arrow direction shown, and disconnect the connector.
[[D]] AIR BAG MODULE ASSEMBLY REMOVAL
WARNING:
-
The air bag module must not be measured with such equipment as an ohmmeter.
-
The air bag module must not be disassembled.
-
The removed air bag module should be stored in a clean, dry place with the deployment surface facing up.
Loosen the torx screw and remove the air bag module assembly.
[[E]] STEERING WHEEL ASSEMBLY REMOVAL
Use special tool MB990803 to remove the steering wheel.
[[F]] CLOCK SPRING REMOVAL
WARNING: The removed clock spring should be stored in a clean, dry place.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of air bag modules only according to the specified procedure.
1. When installing the new air bag modules and clock spring, refer to "INSPECTION".
2. Connect the negative (-) battery cable.