Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
As shown in the figure, align the edge of front wheel speed sensor marking with the edge of clip, then perform the installation.
INSPECTION
WHEEL SPEED SENSOR CURRENT CHECK
CAUTION:
Do not connect the battery terminals in reverse as the wheel speed sensor may be damaged.
1. Connect the circuit tester to the wheel speed sensor using the special tool extra fine probe (MB992006), and measure the sensor current as a single
unit.
NOTE:
When measuring at the front wheel speed sensor
^
Do not remove the front wheel speed sensor from the knuckle.