Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Q: Is ETACS-ECU connector C-315 and cigarette lighter connector C-26 in good condition?
YES : Go to Step 5.
NO : Repair the defective connector.
STEP 5. Check the power supply circuit to the cigarette lighter. Measure the voltage at cigarette lighter connector C-26.
1. Disconnect the connector, and measure at the wiring harness-side connector.
2. Turn the ignition switch to the ACC position.
3. Measure the voltage between cigarette lighter connector C-26 terminal No.2 and ground.
-
The voltage should measure approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES : Go to Step 7.
NO : Go to Step 6.
STEP 6. Check the wiring harness between cigarette lighter connector C-26 terminal No.2 and ETACS-ECU connector C-315 terminal No.3.
-
Check the power supply lines (battery power supply) for open circuit and short circuit.
Q: Is the wiring harness between cigarette lighter connector C-26 terminal No.2 and ETACS-ECU connector C-315 terminal No.3 in good condition?
YES : Go to Step 7.
NO : Repair the wiring harness.
STEP 7. Check the ground circuit to the cigarette lighter. Measure the resistance at cigarette lighter connector C-26.
1. Disconnect the connector, and measure the resistance available at the wiring harness side of the connector
2. Measure the resistance value between cigarette lighter connector C-26 terminal No.1 and ground.
-
The resistance should be 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES : Go to Step 9.
NO : Go to Step 8.
STEP 8. Check the wiring harness between cigarette lighter connector C-26 terminal No.1 and the ground.
-
Check the ground wires for open circuit.
Q: Is the wiring harness between cigarette lighter connector C-26 terminal No.1 and the ground in good condition?
YES : Go to Step 9.
NO : Repair the wiring harness.
STEP 9. Retest the system
Check that the cigarette lighter operates normally.
Q: Is the check result normal?
YES : The trouble can be an intermittent malfunction.
NO : Replace the cigarette lighter.
STEP 10. Retest the system
Check that the cigarette lighter operates normally.