Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Cross-Member: Service and Repair
Rear Roll Stopper and Crossmember
REAR ROLL STOPPER AND CROSSMEMBER
REMOVAL AND INSTALLATION
CAUTION:
^
Before removing the steering wheel assembly and driver's air bag module assembly, always refer to Service Precautions, and Air Bag
Module(s) and Clock Spring. Also, position the front wheels in a straight-ahead direction, and remove the ignition key. If you fail to do
this, clock spring for SRS may get damage, making the SRS (air bag) inoperative, and it may cause a serious injury to the driver.
^
The parts indicated by * are the bolts/nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and
soiling from the bearing and thread surfaces, and tighten them to the specified torque.
^
After installation, perform calibration to make ASC-ECU learn the neutral position of the steering wheel sensor.
Pre-removal & Post-installation Operation