Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Rear Knuckle: Service and Repair
KNUCKLE
REMOVAL AND INSTALLATION
CAUTION
^
The parts indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb
weight condition.
^
The parts indicated by *2 are the nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling
from the bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal & Post-installation Operation
Removal Steps 1-6
Required Special Tools:
^
MB991897 or MB992011: Ball Joint Remover