Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
^
Do not remove O-rings and clips from the clutch tube assembly A and clutch master cylinder.
^
If the O-ring or clip is damaged, replace the relevant clutch tube assembly A or clutch master cylinder.
[B] CLUTCH MASTER CYLINDER REMOVAL
Pull out the clutch master cylinder while rotating it 450 to the direction of the arrow shown in the figure.
INSTALLATION SERVICE POINTS
[A] CLUTCH TUBE ASSEMBLY A CONNECTION
CAUTION
^
When connecting the clutch tube assembly A and clutch master cylinder, check that the O-ring and clip are not damaged.
^
If any connection areas of clutch tube assembly A and clutch master cylinder or O-ring is dirty, clean with the clutch fluid.
Assemble the clip to the clutch master cylinder. Then, connect the clutch tube assembly A to the clutch master cylinder.
[B] CLUTCH INTERLOCK SWITCH INSTALLATION