Lancer LS L4-2.0L SOHC (2002)
Blower Motor: All Technical Service Bulletins
A/C - Blower Motor Failure
No.: TSB-03-51-001
DATE: January, 2003
MODEL: 2002-03 Lancer
SUBJECT:
HVAC BLOWER MOTOR FAILURE
(WIPER PIVOT SHAFT GROMMET INSTALLATION)
PURPOSE
This bulletin contains procedures for installing special wiper pivot caps (grommets) onto the wiper pivot shafts to keep water from entering the blower
motor. Water entry can cause blower motor failure.
AFFECTED VEHICLES
2002-03 Lancer built before September 25, 2002
PROCEDURE
Refer to Group 51, WINDSHIELD WIPER AND WASHER in the service manual.
1.
Remove both wiper/wiper arm assemblies.
2.
Place a new grommet on each wiper pivot shaft. Be sure to put the correct grommet on its shaft. The grommet for the driver's side wiper shaft is
marked with a "D". Some passenger's side grommets are marked with an "A" while others may not be have this mark. You can also determine the
correct part by looking at the height of the grommet. The passenger's side grommet is the taller of the two and the outside edges rise from the
bottom at a steeper angle than the driver's side. See the PARTS INFORMATION section of this bulletin.