Lancer LS L4-2.0L SOHC (2002)
1. Connect scan tool MB991502 to the data link connector.
2. Connect SWS monitor kit MB991862 to the column switch connector.
3. Select "TURN SIGNAL - TURN-SIG RH" (FUNCTION DIAG), and check that normal conditions are displayed on the items described in the
table.
Q: Are normal conditions displayed on the "T/S RH SW" and "IG SW(IG1)"?
YES: Replace the ETACS-ECU. Check that the turn-signal lights illuminate normally.
NO:
-
Normal condition is not displayed on the "T/S RH SW": Refer to Inspection Procedure L-5 "ETACS- ECU does not receive a signal from
the turn-signal RH switch."
-
Normal condition is not displayed on the "IG SW (IG1)": Refer to Inspection Procedure L-2 "ETACS-ECU does not receive a signal from
the ignition switch (IG1)."
Inspection Procedure J-2
Flasher Timer: Hazard Warning Lights do not Illuminate