Lancer LS L4-2.0L SOHC (2002)
3. Use special tool MB991204 to tighten rack support cover to 23 ± 2Nm (17 ± 1 ft. lbs.).
4. Turn the rack support cover by 30 degree counterclockwise.
5. Use special tool MB991204 to hold the rack support cover, and then tighten the jam nut to 59 ± 10 Nm (44 ± 7 ft. lbs.).
>>K<< TOTAL PINION TORQUE ADJUSTMENT
CAUTION:
^
When adjusting, set at the highest value of the standard value range.
^
Be sure there is no ratcheting or catching when operating the rack towards the shaft
^
Measure the tool pinion torque through the whole stroke of the rack.
NOTE: If the total pinion torque cannot be adjusted to the standard value within the specified return angle, check the rack support cover
components and replace any parts if necessary.
1. Using special tool MB991006, rotate the pinion shaft at the rate of one rotation in four to six seconds to check the total pinion torque and the
change in torque.
Standard value:
Tool pinion torque: 0.6 - 1.6 Nm (5.3 - 14.2 inch lbs.)
[Change in torque: 0.4 Nm (3.5 inch lbs.) or less]
2. If the total pinion torque or the change in torque is outside the standard value, return the rack support cover within 0 degree angle to 30
degree angle, and adjust again.
>>L<< TAB WASHER/TIE ROD INSTALLATION
After installing tie rod to rack, fold tab washer end (two locations) to tie rod notch
>>M<< BELLOWS BAND INSTALLATION