Lancer Sportback L4-2.4L (4B12) (2010)
2. Measure the resistance between terminal number 2 and terminal number 3 when each of the "ON/OFF", "CANCEL", "COAST/SET" and
"ACC/RES" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance
values are correct.
3. Check that the cruise control switch illuminates when a positive battery terminal is connected to the connector terminal number 4, and terminal
number 1 is grounded.
STOPLIGHT SWITCH CHECK
Refer to Brake Pedal - Inspection - Stoplight Switch Check. See: Lighting and Horns/Brake Light Switch/Testing and Inspection
CLUTCH SWITCH CHECK [M/T]
Refer to On-vehicle Service - Clutch Switch Check. See: Sensors and Switches/Sensors and Switches - Starting and Charging/Clutch Switch/Testing and
Inspection/Clutch Switch Check
TRANSMISSION RANGE SWITCH ("N" POSITION) [CVT]
Refer to On-vehicle Service - Essential Service - Transmission Range Switch Continuity Check. See: Transmission and Drivetrain/Continuously
Variable Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/Transmission Range Switch Continuity Check
THROTTLE ACTUATOR CONTROL MOTOR
Refer to On-vehicle Service - Throttle Actuator Control Motor Check [2.0L ENGINE.] See: Powertrain Management/Computers and Control