Lancer Sportback L4-2.4L (4B12) (2010)
/Page-363001.png)
Oil Pressure Switch (For Fuel Pump): Service and Repair
ENGINE OIL PRESSURE SWITCH
REMOVAL AND INSTALLATION [2.4L ENGINE]
Pre-removal & Post-installation Operation
Removal Steps 1-2
Required Special Tool:
^
MB992118: Oil Pressure Switch Wrench
REMOVAL SERVICE POINTS
[A] THROTTLE BODY MOUNTING BOLTS REMOVAL
Remove the throttle body mounting bolts and put the throttle body aside so as not to interfere the engine oil pressure switch connector disconnection.
[B] ENGINE OIL PRESSURE SWITCH REMOVAL
CAUTION
The sealant is applied to the bolt. Remove the bolt with care not to break it.
