Lancer Sportback L4-2.4L (4B12) (2010)
3. Measure the voltage between data link connector terminal 6 and body ground. [CAN_H]
OK: 1 volts or less
4. Measure the voltage between data link connector terminal 14 and body ground. [CAN_L]
OK: 1 volts or less.
Q: Do all the voltage measure 5 volts or less?
YES : Go to Step 5.
NO : Repair the wiring harness between data link connector C-34 and ETACS-ECU connector C-301.
STEP 5. Check the wiring harness between data link connector C-34 and ETACS-ECU connector C-301 for line-to-line short. Measure the
resistance at data link connector C-34.
1. Disconnect the scan tool and ETACS-ECU connector C-301, and measure the resistance at the wiring harness side of data link connector C-34.
2. Measure the resistance between data link connector terminal 6 and 14.
OK: No continuity
Q: Is the check result normal?
YES : Go to Step 6.
NO : Repair the wiring harness between data link connector C-34 and ETACS-ECU connector C-301.