Lancer Sportback L4-2.4L (4B12) (2010)
STEP 3. Check the wiring harness between joint connector (CAN2) C-05 and AWC-ECU connector C-51 for line-to-line short. Measure the
resistance at joint connector (CAN2) C-05.
CAUTION:
-
Disconnect the negative battery terminal.
-
A digital multimeter should be used.
-
The test wiring harness should be used.
1. Disconnect joint connector (CAN2), and check that there is continuity at the harness side of joint connector (CAN2).
2. Check that there is continuity between joint connector (CAN2) terminals 4 and 15.
OK: No continuity
Q: Is the check result normal?
YES : Go to Step 4.
NO : Go to Step 13.
STEP 4. Check the wiring harness between joint connector (CAN2) C-05 and ETACS-ECU connector C-301 for line-to-line short. Measure the
resistance at joint connector (CAN3) C-05.
CAUTION:
-
Disconnect the negative battery terminal.
-
A digital multimeter should be used.
-
The test wiring harness should be used.
1. Disconnect joint connector (CAN2), and check that there is continuity at the harness side of joint connector (CAN2).
2. Check that there is continuity between joint connector (CAN2) terminals 6 and 19.
OK: 120 ± 20 ohm
Q: Is the check result normal?
YES : Go to Step 5.
NO : Go to Step 14.