Lancer Sportback L4-2.4L (4B12) (2010)
2. Check the wiring harness between joint connector (CAN1) C-06 (terminal 7) and CAN box unit connector C-108 (terminal 8)
OK: Continuity exists (2 ohm or less)
3. Check the wiring harness between joint connector (CAN1) C-06 (terminal 20) and CAN box unit connector C-108 (terminal 9)
OK: Continuity exists (2 ohm or less)
Q: Is the wiring harness between joint connector (CAN1) C-06 and CAN box unit connector C-108 in good condition?
YES : Check the power supply circuit of the CAN box unit. Refer to Diagnosis [MMCS]. See: Testing and Inspection/Diagnostic Trouble Code
Descriptions/MMCS (Mitsubishi Multi Communication System)
NO : Repair the wiring harness between joint connector (CAN1) C-06 and CAN box unit connector C-108.
Diagnostic Item 22
DIAGNOSTIC ITEM 22: Diagnose when the scan tool cannot receive the data sent by hands free module. (vehicles with hands free cellular
phone system)
CAUTION: When servicing a CAN bus line, ground yourself by touching a metal object such as an unpainted water pipe. If you fail to do so, a
component connected to the CAN bus line may be damaged.