Lancer Sportback L4-2.4L (4B12) (2010)
Engine Control Module: All Technical Service Bulletins
Engine Controls - MIL ON/DTC's P2096/P2097/P0133
No: TSB-11-13-001
DATE: January, 2011
MODEL: See below
SUBJECT:
ECM REPROGRAMMING FOR DTCS P2096, P2097, OR P0133
PURPOSE
Some affected vehicles may exhibit MIL illumination with DTC P2096, P2097, or P0133 stored in the ECM due to incorrect ECM software parameters.
This TSB provides instructions to reprogram the ECM with new parameters to correct the condition. The 02 sensor may not be defective and should not
be replaced unless the symptoms return after reprogramming is completed, the vehicle is test driven, and further DTC diagnosis is performed.
IMPORTANT:
If an affected vehicle has a Malfunction Indicator Lamp (MIL) illuminated, and DTCs stored in the ECM other than those described in this TSB,
diagnose and repair those DTCs per the service manual before reprogramming. DO NOT reprogram the ECM until the reason for any other DTCs
being set is corrected.
AFFECTED VEHICLES
2010 Lancer with with non-turbocharged engine
2010 Lancer Sportback with non-turbocharged engine
REQUIRED OPERATIONS
The following equipment is needed to reprogram the ECM.
^ MEDIC-II laptop computer with A/C power adaptor - 520924, or M1T547708.
^ VCI (Vehicle Communication Interface) - MB991824.
^ MUT-III main harness A' (blue DLC connector) - MB991910.
^ USB 2.0 cable - MB991827.
^ "Engine Compartment/Control Module" label - p/n MSSF024G00.
^ MEDIC-II Download at M409 or higher.
^ For Standalone MUT-III laptops, MUT-III version 24 (or later).
ECM REPROGRAMMING CHART (4B12 - 2.4L)