Lancer Sportback L4-2.4L (4B12) (2010)
/Page-957009.png)
Use the analog type tester to make sure the electrical continuity of each diode meets the table.
Unless the electrical continuity of each diode meets the table, replace the rectifier.
RECTIFIER ASSEMBLY [2.4L ENGINE]
1. Check the condition of the (+) heat sink by checking the continuity between the (+) heat sink and each of the stator coil lead connecting terminals.
If the continuity is present for both terminals, or if no continuity is present for both terminals, the diode is shorted. Replace the rectifier assembly.
2. Check the condition of the (-) heat sink by checking the continuity between the (-) heat sink and each of the stator coil lead connecting terminals.
If the continuity is present for both terminals, or if no continuity is present for both terminals, the diode is shorted. Replace the rectifier assembly.
BRUSH [2.0L ENGINE]
1. Measure the length of the protrusion of the brush. Replace the brush if the protrusion length is shorter than the limit.
Limit: 2 mm (0.08 inch) minimum