Mirage L4-1795cc 1.8L SOHC 16 Valve (1995)
8. If the sensor does not generate 0.6 - 1.0 V, replace the heated oxygen sensor.
Rear
1. Disconnect the heated oxygen sensor connector.
2. Make sure that there is continuity [Approx. 20 Ohms at 20°C (68°F)] between terminals No. 2 and terminal No. 4 on the heated oxygen sensor
connector.
3. If there is no continuity, replace the heated oxygen sensor.
NOTE
1. If the scan tool does not display the standard value although no abnormality is found by the above-mentioned continuity test and harness check,
replace the heated oxygen sensor.