mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3392 > < Diagram Information and Instructions|Page 3389
Page 1
background image

Idle Air Control Motor (DC Motor): Initial Inspection and Diagnostic Overview

Hint 1: While the engine is idling, if the idle speed and servo valve position (step) change when the air conditioning switch is turned to ON and OFF, it
can be assumed that the idle air control motor and the servo valve position sensor are operating normally.

Hint 2: If the servo valve position (step) is outside the standard position, the malfunction is probably one of the following:

1. Basic idle speed adjustment is wrong.
2. Some deposit is adhering to the throttle valve.
3. Air is being drawn into the air intake manifold through a defective gasket seal.
4. EGR valve not seated.
5. Combustion malfunction inside a cylinder. (Spark plug, ignition coil, injector or compression pressure is defective.)

Initial Inspection and Diagnostic Overview|Page 3392 > < Diagram Information and Instructions|Page 3389