Mirage Sedan LS L4-1834cc 1.8L SOHC MFI (1999)
Body Emblem: Service and Repair
REMOVAL AND INSTALLATION
INSTALLATION SERVICE POINT
MARK INSTALLATION
Each dimension from the edge to the notch of the mark should be equal to each installation dimension. (i.e. A=A', B=B', C=C')
MITSUBISHI MARK
GRADE MARK <ES, LS, DE>
1. Clean the mark installation surfaces on the body with unleaded gasoline.
2. Peel off the backing paper from the reverse side of the marks, and then attach the marks to the vehicle body so that they fit properly into position.
CAUTION: When attaching the marks, the surrounding temperature should be 20 - 38° C and the air should be completely free from dust.
If the surrounding temperature is lower than 20° C, the marks and the places on the body where the marks are to be attached should be heated to
20 - 38° C.