Mirage Sedan LS L4-1834cc 1.8L SOHC MFI (1999)
(2) Remove the crossmember while supporting it with a transmission jack.
INSTALLATION SERVICE POINTS
>A< STABILIZER BAR INSTALLATION (Except 2-door models)
Place the identification mark of the stabilizer bar to the left, and install the bushing so that the identification mark protrudes approximately 10 mm
(0.4 inch) from the edge of the inside of the bushing.
>B< SELF-LOCKING NUT INSTALLATION (Except 2-door models)
Tighten the self-locking nut so that the amount of protrusion of the end of the stabilizer bar mounting bolts is at the standard value.
Standard value (A): 22 mm (0.9 inch)
INSPECTION
-
Check the crossmember for cracks or deformation.