Mirage Sedan LS L4-1834cc 1.8L SOHC MFI (1999)
Using the special tool, loosen the bolts in 2 or 3 steps in the order of the numbers, and remove the cylinder head assembly.
CAUTION: Because the plug guides cannot be replaced by themselves, be careful not to damage or deform them when removing the cylinder
head bolts.
INSTALLATION SERVICE POINTS
>A< CYLINDER HEAD GASKET INSTALLATION
1. Wipe off all oil and grease from the gasket mounting surface.
2. Install so that the cylinder head holes match the respective cylinder head gasket holes.
>B< CYLINDER HEAD BOLT INSTALLATION
1. When installing the cylinder head bolts, the length below the head of the bolts should be within the limit. If it is outside the limit, replace the
bolts.
Limit (A): 96.4 mm (3.80 inch)
2. The head bolt washer should be installed with the burred side, caused by tapping out, facing upwards.
3. Apply a small amount of engine oil to the thread section and the washer of the cylinder head bolt.