Mirage Sedan LS L4-1834cc 1.8L SOHC MFI (1999)
Throttle Cable/Linkage: Adjustments
ACCELERATOR CABLE CHECK AND ADJUSTMENT
1. Turn off the air conditioning and all lights. Inspect and adjust at no load.
2. Start the engine and allow to idle until it reaches normal operating temperature.
3. Confirm idle speed is at standard value.
Standard value:
800 ± 100 rpm
4. Stop engine (ignition switch OFF).
5. Confirm there are no sharp bends in accelerator cable.
6. Check inner cable for correct slack.
Standard value: 1 - 2 mm (0.04 - 0.08 in.)
7. If there is too much slack or no slack, adjust the cable as follows:
1. Loosen the adjusting bolt to release the cable.
2. Move the plate until the inner cable play is at the standard value, and then tighten the adjusting bolt to the specified torque.
8. Adjust accelerator cable play and confirm throttle lever stopper touches the fixed SAS.