mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Restraints - Revised Clockspring Alignment Procedure|Page 5144 > < Restraints - Revised Clockspring Alignment Procedure|Page 5142
Page 2
background image

1. Negative (-) Battery Cable Disconnection

Disconnect the negative battery cable from the battery and tape the terminal.

CAUTION:  Wait at least 60 seconds after disconnecting the battery cable before doing any further work. 

2. Air Bag Module Removal (driver's Side)

a. Remove Cover.
b. Remove air bag.

When disconnecting the connector of the clock spring from the air bag module, press the air bag's lock toward the outer side to spread it open. Use
a flat-tipped screwdriver to pry gently as shown in the figure at the left, to remove the connector

CAUTION
-

When disconnecting the air bag module-lock spring connector, take care not to apply excessive force to it.

-

The removed air bag module should be stored in a clean, dry place with the pad cover face up.

3. Remove Steering Wheel 

CAUTION:  Do not hammer on the steering wheel. Doing so may damage the collapsible column mechanism.

4. Remove Column cover lower

5. Clock Spring Removal

CAUTION:  The removed clock spring should be stored in a clean, dry place.

INSTALLATION

To install reverse the removal steps and note the following.

Pre-installation Inspection

Restraints - Revised Clockspring Alignment Procedure|Page 5144 > < Restraints - Revised Clockspring Alignment Procedure|Page 5142