Mirage Sedan LS L4-1834cc 1.8L SOHC MFI (1999)
Tie Rod End: Testing and Inspection
TIE-ROD END BALL JOINT BREAKAWAY TORQUE CHECK
1. Disconnect tie-rod and knuckle with special tool.
CAUTION:
1. Using the special tool, loosen the tie-rod end mounting nut. Only loosen the nut; do not remove it from the ball joint.
2. Support the special tool with a cord, etc. to prevent it from coming off.
2. Move ball joint stud several times and install nut on the stud. Measure the ball joint breakaway torque with special tools.
Standard value: 0.20 - 0.48 Nm (1.7 - 4.3 inch lbs.)
3. If the measured value exceeds the standard value, replace the tie-rod end.
4. If the measured value is lower than the standard value, check that ball joint turns smoothly without excessive play. If so, it is possible to use that
ball joint.