Testing and Inspection for Front Wheel Bearing in Mirage Sedan LS (1999)
Wheel Bearing: Testing and Inspection
Rear
WHEEL BEARING END PLAY CHECK
1. Remove the brake drum.
2. Check the bearing's end play.
Place a dial gauge against the hub surface; then move the hub in the axial direction and check whether or not there is end play.
Limit: 0.05 mm (0.0020 inch)
3. If the end play exceeds the limit, the flange nut should be tightened to the specified torque [172 Nm (127 ft. lbs.)] and check the end play again.
4. Replace the rear hub assembly if an adjustment cannot be made to within the limit.