Montero V6-3.8L SOHC (2005)
^
The wire between combination meter connector D-03 (terminal 55) and M-ASTC-ECU connector E-121 (terminal 81)
NOTE: Also check intermediate connector E-111 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If
intermediate connector E-111 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection. If the
connector has been repaired or replaced, go to Step 4.
Q: Is the harness wire damaged?
YES: Repair or replace it and then go to Step 4.
NO: Replace the combination meter and then go to Step 4.
STEP 4. Retest the system.
Q: Does the brake warning light turn on for three seconds and then turn off on start-up?
YES: The procedure is complete.
NO: Start over at Step 1.
Inspection Procedure 3
INSPECTION PROCEDURE 3: DTC 53 <Seizure of the Pump Motor>, DTC 55 or DTC 57 is set, but the Buzzer does not Sound.