Montero V6-3.8L SOHC (2005)
Use special tools MD998715 and MB990767 to remove the camshaft sprocket.
<<B>> ROCKER ARM AND SHAFT ASSEMBLY REMOVAL
1. Install special tool MD998443 as shown in the illustration so that the lash adjusters will not fall out.
CAUTION: Never disassemble the rocker arm and shaft assembly.
2. Loosen the rocker arm and shaft assembly mounting bolt, and then remove the rocker arm and shaft assembly with the bolt still attached.
<<C>> VALVE SPRING RETAINER LOCKS REMOVAL
CAUTION: When removing valve spring retainer locks, leave the piston of each cylinder in the Top Dead Center (TDC) position. The valve
may fall into the cylinder if the piston is not properly in the TDC position.
Use special tool MD998772 to compress the valve spring, and remove the valve spring retainer locks.
