Montero V6-3.8L SOHC (2005)
2. Press the "ADJ" switch [next].
The screen changes to the service mode second menu screen.
3. Press the function switch 1 [MONITOR] on the service mode second menu screen.
The screen is switched to the monitor check mode.
4. Press the function switch 2 [COMP.].
-
<Normal case that the body is not magnetized>
The geomagnetic sensor mode screen is displayed. Each of X- and Y-outputs of the geomagnetic sensor, center coordinates, and radius of the
direction circle are displayed. For degeomagnetization, refer to Vehicle Magnetic Compensation.
-
<Case that the body is magnetized>
If the sensor value is outside the range between 450 and 580, it is meant that the body is magnetized. The screen that calls upon to demagnetize
the body stating "Demagnetize within range of acceptable level" is displayed. In this case, it is necessary to demagnetize the body and to
correct the geomagnetic sensor. Refer to on-vehicle service-vehicle magnetic compensation.
-
When function switch 1 [CAL.COMP] is pressed at the previous screen, a message of urging rotation compensation is displayed. For the