mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Information Bus|Testing and Inspection > < Information Bus|Description and Operation|Page 1917
Page 4
background image

system generates turn-signal light drive signals (flashing signals). The system also notifies of a blown turn-signal light bulb by shortening the flashing
intervals of the corresponding indicator light.

Hazard warning light

The system detects a change from OFF to ON of the hazard warning input signal and activates or shuts off the hazard warning lights accordingly.

FOG LIGHT

The fog light switch becomes active only when the headlights are at the low-beam mode. Therefore, if the headlights are turned off, the fog lights will
also be switched off. When the headlights are turned on during the next key cycle, the fog lights will be off regardless of the fog light switch position.

DOME LIGHT

With the dome light switch in the "door controlled operation" (middle) position, the ETACS-ECU controls the dome light operation as follows:

-

When a door is opened from outside or inside [with the ignition switch turned to "LOCK" (OFF): When a door is opened, the ETACS-ECU causes
the dome light to be illuminated at 100% intensity. When the door is closed, it dims the dome light to 65% intensity and approximately 30 seconds
later, turns out the light completely. During this period (timer controlled period), the dome light goes out if the ignition switch is turned "ON" or
the doors are locked.

-

When a door is opened or closed with the ignition switch in the "ON" position: The dome light illuminates at 100% intensity when a door is
opened and turned out when it is closed.

-

When no door is opened and the ignition key is removed: The dome light is illuminated at 100% intensity and turned off approximately 30
seconds
 later. During that time (timer-controlled period), the dome light goes out if the ignition key is inserted and turned to "ON" or the door
locking system is activated.

-

Dome light's answerback operation in response to door lock control by keyless entry system: To allow the driver to confirm the doors have locked
by the keyless entry system, the ETACS-ECU causes the dome light to blink twice when the doors are locked by the RKE system and to illuminate
for approximately 15 seconds when the doors are locked. The dome light's answerback operation in response to a keyless entry system control
action is accompanied by flashing of the hazard warning lights.

THEFT-ALARM SYSTEM

Theft-alarm System Operation

If a door, back door or hood is opened, when the theft-alarm system has been armed the horn (theft-alarm horn and horn) will sound and headlights flash
(high-beam) intermittently for a period of 180 seconds.

Panic Alarm Function

With the theft-alarm function armed, pressing the panic button on the keyless entry system transmitter causes the horn (theft-alarm horn and horn) to
sound for about 180 seconds in an attempt to prevent theft. The alarm is turned off by pressing any switch on the transmitter.

CONFIGURATION FUNCTION

The keyless entry hazard answerback function and the headlight automatic shutdown function can be adjusted by the special operation. Or they can be
returned to the initial condition.

Information Bus|Testing and Inspection > < Information Bus|Description and Operation|Page 1917